I just wanted to announce that i have the stock vapor pro and the vektor 4000 running in my xs on a gens ace 5000 40c 2s lipo since september last year without any problem. To make things clear, i dont drive like my grandmother :twisted:. I only had a little problem... The 3 black esc wires were a tiny bit too small for the plugs on the esc and when i landed a jump, the car stopped. So i made them a little wider at the golden bottom and since then, rock and roll.
The esc and motor run hot, but not extremely hot... They have the same temp as any other brushless motor and esc that i have.
This forum is dedicated to discussion regarding the HPI Savage XS Flux Brushless Electric Vehicle.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest